Please note this is a rescue method as mineral solvents could cause delamination to synthetic carpets – or remove glued down tufts.
- Use sand paper or a knife to gently abrade / score the surface of the stain. Take extra care not to do this to the carpet – Only the solids.
- Apply Solvent spotter – stain remover Via a spray trigger or white cotton terry towel and emulsify the stain.
- Slime will break down and gradually transfer into the towel, Bit by bit.
- Steps 2-3 may need repeating until stain has been completely emulsified.
- Rinse extract the chemical using High Performance rinse, This should be mixed at 30ml per 10 litres in your clean water tank.
- Make slow passes using your cleaning wand and for every wet pass make sure you follow up with at least 2 dry passes. On Polypropylene and Polyester carpets zig zagging and sharks teeth will not permanently disrupt the pile, however for a professional finish leave in a uniform condition.
- If the customer wants to make future occurrences easier to remove: Apply WS Advanced fabric stain protection at 1-1 for a long lasting dirt and hydrophobic barrier. This can be done wet or dry.