Please note this is a rescue method as mineral solvents could cause delamination to synthetic carpets – or remove glued down tufts.
- Pre-vacuum or brush off area.
- Mix High Performance Pre-Spray Pre-spray at 250ml per litre.
- Apply a liberal amount of pre-spray to the carpet using overlapping passes.
- Allow Pre-spray to sit on carpet for 15 minutes. During this time the product will break down soils and deodorise the carpet.
- Brush Pre-spray into carpet using manual or mechanical methods – This step is not always necessary.
- Rinse extract the chemical using High Performance rinse, This should be mixed at 30ml per 10 litres in your clean water tank.
- Make slow passes using your cleaning wand and for every wet pass make sure you follow up with at least 2 dry passes. On Polypropylene and Polyester carpets zig zagging and sharks teeth will not permanently disrupt the pile, however for a professional finish leave in a uniform condition.
- If any stains remain these can be spotted using Solvent spotter – stain remover
- High Performance Pre-Spray does not deodorise, premium deodoriser can be added to your rinse tank or alternatively sprayed lightly at the end.